Picadilli: A 1965 20 ft Water-Jet Inboard Runabout Plan
A 20 ft inboard runabout from 1965 with water-jet drive, built in plywood over sawn frames.
Picadilli is a big, modern-minded runabout for its era. Published in 1965, it is 20 ft (6.1 m) long and built from plywood over sawn frames, with an inboard engine driving a water jet instead of a propeller. That combination promises a clean, open stern and easy running in shallow water. It is a substantial project for an experienced builder, and ten sheets of drawings lay out the work. The finished boat suits family days and longer runs on larger lakes.
Picadilli at a glance
| Detail | Picadilli |
|---|---|
| Type | Inboard runabout |
| Length | 20 ft (6.1 m) |
| Construction | Plywood over sawn frames |
| Power | Inboard engine with water-jet drive |
| Designer | David D. Beach |
| First published | Sports Afield Boatbuilding Annual, 1965, pp. 10–19 |
| Plan sheets | 10 |
Why a water jet
Water-jet drive pushes the boat with a stream of water rather than an exposed propeller. That means nothing spinning below the hull, which is welcome around swimmers and in shallow water where a prop might strike bottom. It also suits the clean, uncluttered stern that makes boarding from the water easy after a swim.
At 20 ft, Picadilli is one of the longer runabouts in this collection, giving room for passengers and a smoother ride. Plywood over sawn frames keeps the construction familiar to anyone who has built a smaller boat, scaled up with the care that a larger hull demands.
The original plan sheets
These are the 10 original sheets from 1965, scanned from the magazine. For building, use the full-size PDF in the download section below.










Who designed it
David D. Beach drew Picadilli for the Sports Afield Boatbuilding Annual of 1965, where it ran on pages 10–19. Beach also designed the 1954 Mucho Gusto inboard runabout for the same annual series.
Before you build
- Choose your water-jet unit before building the stern, so the intake and mounting match the plan's layout.
- Allow workshop space for a 20 ft hull plus room to turn it over safely when the bottom is done.
- Ventilate the inboard engine compartment well and fit a bilge blower before the first start.
Download the plan
The 1965 Picadilli plan in one file: ten sheets at full size, ready to print or keep open on a shop tablet.
Comments
No comments yet. Be the first to say what you think of this post.