Playboy: A Free 1958 Mahogany-Sided Runabout Plan
A 1958 runabout, 13 ft 6 in long, with mahogany plywood sides, seating up to six and running at 25–32 mph.
Playboy has the polish of a classic mahogany runabout in a build that stays within reach. It is 13 ft 6 in (4.11 m) long with a 5 ft 9 in (1.75 m) beam, seating two forward and three or four aft. A 3/8 in plywood convex bottom pairs with 1/4 in mahogany plywood sides that varnish up beautifully. The plan quotes 32 mph with a 1953 Evinrude or Johnson 25 and 25 mph with a Martin 20. It is made for sunny afternoons and admiring glances at the dock.
Playboy at a glance
| Detail | Playboy |
|---|---|
| Type | Outboard runabout |
| Length | 13 ft 6 in (4.11 m) |
| Beam | 5 ft 9 in (1.75 m) |
| Capacity | 2 forward, 3–4 aft |
| Construction | 3/8 in. plywood convex bottom, 1/4 in. mahogany plywood sides |
| Power | Evinrude or Johnson 25 (1953): 32 mph; Martin 20: 25 mph |
| Designer | William D. Jackson |
| First published | Boat Builder's Handbook, Volume 8, 1958, p. 32 |
| Craft Print | No. 201 |
| Plan sheets | 10 |
Looks and pace together
Mahogany plywood gives that warm, glossy finish people associate with vintage runabouts, without the cost and complexity of solid planking. Under the varnish, the thicker 3/8 in bottom handles the pounding at speed while the lighter sides keep weight sensible. The combination looks rich on the water and stays practical to trailer and launch.
Split seating, two forward and three or four aft, makes it a genuine family boat rather than a two-seat toy. The quoted speeds for period 20 and 25 hp motors show it was designed to perform with moderate power, which is good news for both your fuel bill and your trailer.
The original plan sheets
These are the 10 original sheets from 1958, scanned from the magazine. For building, use the full-size PDF in the download section below.










Who designed it
William D. Jackson drew Playboy for the Boat Builder's Handbook, Volume 8, published in 1958, page 32, as Craft Print 201. Its speed figures, quoted with named outboards of the day, still make a handy benchmark for builders choosing an engine.
Before you build
- Match your outboard to the 20–25 hp class the plan was tested with, and do not exceed it.
- Seal and varnish the mahogany plywood sides with several coats, sanding lightly between each for a deep finish.
- Load the aft seats evenly so the convex bottom planes level rather than bow-high.
Download the plan
The 1958 Playboy plan in one file: all ten sheets at full size, ready to print or keep open on a tablet.
Download the complete plan (PDF, 10 sheets, 6.8 MB)
Tools for this
Comments
No comments yet. Be the first to say what you think of this post.