Panther: A Free 1958 Plan for a Car-Engined Speed Runabout
William D. Jackson's 1958 15 ft inboard runabout runs on a Ford or Mercury car engine, at up to 75 mph.
Panther is pure 1950s hot-rod spirit, translated to water. William D. Jackson designed this 15 ft (4.6 m) plywood runabout in 1958 to take an automobile engine: a '54 or later unit, or a souped-up '46 to '49 Ford or Mercury. The plan quotes speeds of up to 75 mph. It is an ambitious build for someone who loves engines as much as boats.
Panther at a glance
| Detail | Panther |
|---|---|
| Type | Inboard runabout |
| Length | 15 ft (4.57 m) |
| Construction | Plywood over frames and stringers with engine bed and hood |
| Power | Automobile engine ('54 or later, or souped '46–'49 Ford or Mercury); up to 75 mph |
| Designer | William D. Jackson |
| First published | Boat Builder's Handbook, Volume 8, 1958, p. 12 |
| Craft Print | No. 286 |
| Plan sheets | 14 |
Built for speed
Plywood over frames and stringers gives a light but strong hull, with a dedicated engine bed and hood to house a car engine. Stringers run fore and aft to spread the engine's weight and thrust through the boat. Fit and alignment here decide how smoothly the whole boat runs.
The 75 mph figure comes with a hot automobile engine, so this is a boat for experienced hands. Fourteen sheets reflect how much detail an inboard of this kind requires. For anyone who loves both cars and boats, it is a project that brings the two worlds together. Take the build slowly, as precision matters at every step.
The original plan sheets
These are the 14 original sheets from 1958, scanned from the magazine (the first 12 are shown here). For building, use the full-size PDF in the download section below.












Who designed it
William D. Jackson drew Panther for the Boat Builder's Handbook, Volume 8, 1958, page 12, and it was issued as Craft Print No. 286. Jackson was a mainstay of the Science and Mechanics craft print catalogue.
Before you build
- Marinize any car engine properly, with cooling, exhaust and ignition suited to a boat, before installing it.
- Build the engine bed and stringers exactly as drawn, since they carry all of the engine's weight and torque.
- Ventilate the engine compartment well and test at moderate speed before ever exploring the top end.
Download the plan
The complete 1958 Panther plan in one file: all fourteen sheets, including the engine bed and hood.
Download the complete plan (PDF, 14 sheets, 13.3 MB)
Tools for this
Comments
No comments yet. Be the first to say what you think of this post.